#3 Pro-Wick Rosin ESD-Safe Desoldering Braid, Green, 0.075" dia. x 5' Spool

FAQs

How are Techspray's desoldering braid products classified?

Techspray uses 2 types of flux: Prowick line is a natural gum rosin. Per J-STD-004 Section 3.2, the Prowick is classified as ROL0. Per British Std. EN 29454-1:1993 and ISO9454-1:1990, Prowick has a classification of 1.1.1.B. No-Clean flux is a synthetic (non-colophony)flux. Per J-STD-004 Section 3.2, it is classified as REL0. Per British Std. EN 29454-1:1993 and ISO9454-1:1990, the No-Clean flux has a classification of 1.2.3.B.

Can solder be undone?

All you need is Techspray desoldering braid (wick) and a soldering iron. Here are the basic instructions:

1. Place the braid over unwanted solder, preferably on the greatest solder build up so that it maximizes the contact of the braid to the surface area of the solder.
2. Next, place your iron tip over the wick at 45 degrees and allow heat to transfer to the pad. Molten solder will absorb into the braid.
3. Move the solder tip and braid as needed to remove all of the solder at one time. Careful not to drag the braid over the pads, which can scratch.
4. Once the braid is full of solder, you must trim the spent portion and move to a fresh braid in order to pull more solder. Remove the iron and braid simultaneously to avoid soldering the wire to the board.