Chemtronics ES1015

Ultrajet 70 Duster, 10 oz. Can

In Stock Ships HAZMAT

Ultrajet^® 70 is an economical general-purpose air duster with a new BIGGER blast for electronic applications. Its exceptional purity jet instantly cleans surfaces free of particulate contamination. Ultrajet^® 70 is engineered to remove dirt, dust, oxide particles and other airborne particles instantly, and can be used to facilitate the accelerated drying of solvent cleaners.

Nonflammable
Highest powered cleaning strength
Zero VOC
Filtered to 0.2 microns
Leaves no residue
Safe on plastics
Bigger blast than competitive dusters

Special Price $17.82 Regular Price $18.37

Buy 12 for $17.64
Buy 50 for $17.45
Buy 100 for $17.27

Skip to the beginning of the images gallery

Technical Documents

SDS/MSDS Sheets

Chemtronics Ultrajet 70 Material Safety Data Sheet (MSDS)

Product Info & TDS Sheets

Chemtronics Ultrajet 70 Product Information

Details

FAQs

How can I stop a can of "canned air" aerosol duster from freezing up?

This phenomenon occurs due to the expansion of the compressed refrigerant liquid as it dispenses through the aerosol valve and flashes to a gas. If the aerosol is operated for a long period, frost may form on the can because it is freezing the surrounding water vapor from the air. If it is collecting on the material to be cleaned, the operator is dispensing for too long of a period or is dispensing it too close to the material. The frost will evaporate and leave no residue. However, particulate matter blown onto a sensitive surface may cause damage due to the high pressure of the duster if dispensed too closely to that surface.

How do I properly dispose of an erosol can after it is empty?

It may be different state-by-state, so contact your state environmental agency for regional specific regulations. For a general guideline, here is the process according to EPA hazardous waste regulations 40CFR. The can has to be brought to or approach atmospheric pressure to render the can empty. Puncturing is not required, only that it “approach atmospheric pressure”, i.e. empty the can contents until it’s no longer pressurized. This insures that as much contents as is reasonably possible are out of the can. It is then considered “RCRA-empty”. At that point it can be handled as any other waste metal container, generally as scrap metal under the recycling rules. Note that the can is still considered a solid waste at this point (not necessarily hazardous waste).

Is there something I can do with the extension tube (straw) so it doesn't get lost?

The red cap on Chemtronics aerosol products like flux removers, degreasers, and Freeze-It Freeze Spray has a notch on the top. That is engineered for the straw to snap in and hold into place so you don’t loose it. The aerosol trigger sprayers that are common on dusters, freeze sprays, and flux removers, have two ways to store the straw when not in use. The hole at the back of the body of the sprayer is just the right size for the straw to slide into place for storage. The slot below the trigger is also the right size for the straw to snap into place, which also has the advantage of locking the trigger.

*This item is hazardous and will be subject to an additional Hazmat fee.

More Information